Uniquely flexible for a wide range of continuous processing needs, GK’s vibrating fluid bed processors are ideally used for heating, drying, cooling, coating, or elutriation. GK vibrating fluid beds are available in a variety of configurations, and utilize vibratory agitation while passing a process gas through the material bed to suspend the material in a fluidized state. This increases available material surface area, allowing a faster and more complete processing of your material.

Efficient Vibratory Drives
General Kinematics vibrating fluid bed dryers, coolers, and processors can employ various drive systems depending on your process and material specifications. GK’s PARA-MOUNT II® two-mass drive systems use up to 60% less energy than the typical direct drive / brute force configurations found on other vibrating fluid bed designs.

To request more information about GK Fluid Bed Processors, click here.

Related GK News

website translation

FOR IMMEDIATE RELEASE: General Kinematics Website Now Available in Multiple Languages

For Immediate Release General Kinematics                                                                                Marketing Dept.: (815) 444-3594 marketing@generalkinematics.com   FOR IMMEDIATE RELEASE: General Kinematics Website Now Available in Multiple Languages   October 18, 2018, Crystal Lake, IL: General Kinematics Global Headquarters announced today the extensive knowledge platform www.generalkinematics.com, is now available in multiple languages to extend visibility to users across the globe. […]

Read More
Revolution Recovery

Revolution Recovery and GK – C&D Recycling in Delaware

In 2014 Revolution Recovery doubled in size, and decided to invest in a General Kinematics FINGER-SCREEN™ as their Primary Screen. Today, the screen is still running 9 hours per day with minimal maintenance, providing the picking deck with minimum fines and evenly spread material. Check out the full story in the video below!  

Read More

How To Install a Slat Assembly

In this post we will walk through the process of installing a Slat Assembly on General Kinematics Vibratory Equipment.     TAKE NOTE: APPLYING SILICONE IS THE LAST STEP Do not apply silicone to the slat assembly until all of the assembly hardware is torqued This prevents the silicone from getting between the slats, shims, […]

Read More