Two-Mass Vibrating Screens

General Kinematics Two-Mass Screens are unequalled in efficiency and performance. GK’s proven two-mass drive system reduces electrical consumption and increases screening efficiency over traditional direct drive (brute force) designs. Dual in-board vibratory motors eliminate expensive belts, shafts, and bearings for increased uptime, longer service intervals, and the lowest cost of ownership available in a vibratory screen package. Options include replaceable decks, multiple decked units, banana style decks, and special corrosion resistant finishes. GK Two-Mass screens are available in standard and custom sizes to easily fit into existing processes.

Other advantages include:

  • Two-Mass Screens use up to 75% less energy than comparable brute force screens.
  • Easy to swap out for refurbishment… unplug it and remove.
  • No belts, shafts, or expensive bearings.
  • Custom engineered for your specific application.

Click here to request more information on GK’s vibratory two-mass screens.

Related GK News

spending

President’s Blog: Total cost of ownership.

Another day, another call from a foundry that “saved money” buying low-value vibratory equipment from our competition.   This time the call was in reference to a group of machines engineered and manufactured by a company that used erroneous engineering calculations. As a result, from day one of operation, the equipment cracked and broke. This […]

Read More
bolting a rocker leg

How to Change a Rocker Leg

Generally used to guide the movement of the conveying surface in the desired direction, rocker leg (or ductile stabilizer) condition should be inspected as per the pm schedule for each machine.   Once the rocker leg has been identified as needing to be replaced the rocker leg should be replaced immediately to avoid damaging the […]

Read More
Spring Replacement

How to Replace a Spring

In an effort to promote proper maintenance procedures, below is a step-by-step guide to safely replacing pigtail coil springs.   Should a spring that needs to be replaced be found during inspection or while the unit is in operation, it must be replaced immediately to avoid overstressing remaining coil springs as well as causing structural […]

Read More